Hydrochloric acid Essay Example
Hydrochloric acid Essay Example

Hydrochloric acid Essay Example

Available Only on StudyHippo
  • Pages: 2 (481 words)
  • Published: January 11, 2018
  • Type: Experiment
View Entire Sample
Text preview

Introduction

The purpose of this experiment was to examine the oxidation-reduction reaction of magnesium and a hydrochloric acid solution. We compared the amount of product measured in the experiment to the amount predicted by the balanced equation calculation. To start, we obtained a pre-cut strip of magnesium ribbon, cleaned it with steel wool to remove any oxidation, and then weighed it (individual masses of the magnesium strips for each trial can be found in Table I below). Subsequently, we filled a large beaker with warm tap water, filling it more than halfway.

We allowed the water to sit and reach room temperature. At the same time, we filled a 100ml-graduated cylinder with tap water, also at room temperature. To cover it, we used a lid made of plastic wrap, being careful to a

...

void air bubbles underneath. The next step was to invert the graduated cylinder into a beaker filled with water, making sure to remove the lid cautiously. We prepared magnesium ribbon by wrapping it with a short piece of copper wire to prevent it from breaking off during the reaction. Placing the magnesium piece at the bottom of the beaker, under the graduated cylinder, we gently positioned one end of a thistle tube under the inverted graduated cylinder. Finally, we carefully poured 10ml of HCI into the thistle tube.

While the magnesium reacted, we extracted the tube gradually and observed the displacement of water by gas bubbles in the cylinder. After the entire magnesium was used up, we maneuvered the graduated cylinder in the water to even out the water levels. Subsequently, we recorded the quantity of gas accumulated i

View entire sample
Join StudyHippo to see entire essay

the cylinder. There are various potential sources of uncertainty and error in our experiment. For instance, we detected that fragments of our reacting magnesium ribbon could have detached and risen to the surface.

Although there is a possibility that these particles did not react with the HCI, resulting in an inaccurate measurement, another source of uncertainty in our experiment is the escape of some bubbles of Hydrogen gas into the beaker. Despite being careful about removing the thistle tube from under the graduated cylinder after adding the HCI, there is no seal to prevent bubbles from escaping during the reaction of Magnesium. Therefore, the conclusion is that the measurement of gas in all trials was inaccurate, leading to an incorrect calculation of the amount of consumed magnesium and moles. It is important to note that significant figures contribute to increased accuracy in this experiment.The multiplication and division rule in this experiment states that when multiplying or dividing, the result must be reported with the same number of significant figures as the measurement with the fewest significant figures. Measurement is crucial in determining the required number of significant figures, and this must be applied consistently throughout all calculations. The tables above provide examples of the significant figures in each calculation.

Get an explanation on any task
Get unstuck with the help of our AI assistant in seconds
New