Viscosity Experiment Essay Example

style="text-align: justify">The scale of the thermometer went up 1 degree at a time; the scale did not affect my experiment because all my measurements were all Whole numbers, but if they were between two degrees the scale of the thermometer would have been inconvenient. The next step involved me placing a big white piece of paper behind each cylinder as an ordinary backdrop, this will enable me to identify the ball easier and distinguish while it is falling. I then had to choose a ball bearing, which was an average size, to measure the ball bearing I used an micrometre as I thought this piece of equipment was very accurate in measuring very small objects.

I had to wash the ball bearing under water, and wipe with a paper towel, I did this because I thought the charge on the ball bearing could affect its velocity. I repeated this procedure for all ball bearings so that my experiment was not criticised for unreliability. The next part of my experiment involved me dropping the ball bearing through the fluid, but I had to think carefully and take into consideration my reflex reactions, because I was going to time the ball bearing falling between two points with a stopwatch.

After doing several online tests my reflex reactions averaged out to be 0. 2 seconds. I was planning to use light gates at first, as this would have been much more accurate in measuring the time of the fall, but the tube was rather large to have light gates around it, however we will not have access to such expensive equipment in the first place. I

selected two points on the measuring cylinder, 20 and 80; I thought that this was reasonable because, the ball bearing had approximately 15 cm to reach terminal velocity.

So when the bottom of the ball bearing when past the 80 mark at terminal velocity I activated the stopwatch, and when the bottom of the ball bearing went past the 20 mark I deactivated the stopwatch. I personally think that my method did not have any significant risks or hazards. The only minor risk I faced was keeping all the measuring cylinders from knocking over and spilling. To prevent this I put a few weights on the base of the measuring cylinder. Another safety precaution was to keep all ball bearings in a dish; if they were on the floor it could be very dangerous to me and others around me.

The above graph shows a strong negative correlation, the increase in temperature shows the decrease in time. From this graph I can say that this graph is inversely proportional. From these results I am also able to construct a distance- time graph. The gradient of the graph will show the velocity of the ball.

It was necessary to repeat readings, because this would keep my experiment reliable and accurate. I however did not have any odd results, if I was to have any outliers in my results, it would be most likely to be activating and deactivating the stopwatch. The ranges of results were within 1 degree of each other results.

Independent and Dependant Variables

The variables that I will have to keep constant in my first experiment (temperature effect

on viscosity). I will be keep the temperature as the dependant variable and keep all other variables as the independent variables, for example the size of the ball bearing, the same liquid and the same atmosphere. All my variables will be kept constant, the same ball bearing will be used each time, and I will have to use a magnet to take out my ball bearing from the fluid, and then be washed under cold water and then dried on a paper towel. This will keep my experiment fair.