Test out. 7.1.3, 7.2.8, 7.3.6 Practice questions
Unlock all answers in this set
Unlock answersquestion
You want to be able to view the DNS server address that a computer is using. Which of the following utilities would you use?
answer
ipconfig. ifconfig.
question
Examine the following output: Active Connections Proto Local Address Foreign Address State TCP SERVER1:1036 localhost:4832 TIME_WAIT TCP SERVER1:4798 localhost:1032 TIME_WAIT TCP SERVER1:1258 pool-141-150-16-231.mad.east.ttr:24076 CLOSE_WAIT TCP SERVER1:2150 cpe-66-67-255-118.roc.res.rr.com:14100 ESTABLISHED TCP SERVER1:268 C872c-032.cpe.net.cale.rers.com:46360 ESTABLISHED TCP SERVER1:2995 ip68-97-96-186.ok.ok.cox.net:23135 ESTABLISHEDWhich of the following utilities produced this output?
answer
Netstat
question
Which TCP/IP utility gives you the following output?
answer
nbtstat -c.
question
Which TCP/IP utility gives you the following output? Interface: 192.168.4.101 on Interface 0x3 Internet Address Physical Address Type 192.168.1.23 00-d1-b6-b7-c2-af dynamic
answer
arp.
question
You are troubleshooting a connectivity problem on a Linux server. You are unable to connect to another system on the local network, but are not able to connect to a server on a remote network. You suspect that a default gateway information for the system may be configured incorrectly. Which of the following commands would you use to view the default gateway information on a Linux server?
answer
ifconfig.
question
Which TCP/IP utility gives you the following output? Reply from 192.168.1.68: bytes=32 time<10ms TTL=128 Reply from 192.168.1.68: bytes=32 time<10ms TTL=128Reply from 192.168.1.68: bytes=32 time<10ms TTL=128Reply from 192.168.1.68: bytes=32 time<10ms TTL=128 Packets: Sent = 4, Received = 4, Lost = 0 <0% loss>, Approximate round trip times in milli-seconds: Minimum = 0ms, Maximum = 0ms, Average = 0ms
answer
ping.
question
While troubleshooting a problem on a Linux system, you run a utility that generates the following output:
answer
traceroute
question
You manage a network with multiple subnets connected to the Internet. A user reports that she can't access the new server used in the accounting department. You check the problem and find out that her computer cannot access any server on the subnet, however the computer does access other computers on other subnets as well as the Internet. Which of the following is most likely the cause of the problem?
answer
Missing route on the default gateway router.
question
You are the network administrator of a branch office of your company. The branch office network is part of a WAN that covers most of the United States. The office has two Windows 2000 servers, two UNIX severs, one Windows NT server, 90 Windows 98 clients, 40 Windows 2000 Professional clients, and five Macintosh clients. Users have been complaining that they are unable to access resources over the WAN at the main headquarters. You suspect that one of the routers between your office and the main headquarters is not working properly. What TCP/IP utility can you use to see if a router is not working properly?
answer
tracert.
question
You are troubleshooting access to a server in a remote network. You use the tracert command and see the following: Trace route to 192.168.2.250 over a maximum of 30 hops: 1 2 ms 2 ms 2 ms 192.168.12.11 2 2 ms 2 ms 2ms 192.168.11.1 3 5 ms 5 ms 3 ms 192.168.10.15 4 2 ms 2 ms 2 ms 192.168.9.1 5 5 ms 5 ms 3 ms 192.168.11.1 6 2 ms 2 ms 2 ms 192.168.10.15 7 5 ms 5 ms 3 ms 192.168.9.1 ...additional output omittedWhat is the problem?
answer
Routing loop.
question
Which of the following commands would display the output shown here?
answer
route print.
question
You manage a network of multiple subnets connected to the Internet. A user reports that she can't access the Internet. You investigate the problem and find that she can access all hosts on the private network, but no hosts on the Internet. Which of the following is likely the cause of the problem?
answer
Missing default route on a router.
question
You have configured a remote access server to accept dial-up connections for remote access clients. Remote clients are able to connect successfully and access resources on the remote access server. However, the remote clients are not able to connect to other devices located on the same subnet where the remote access server is located.Which action would likely correct the problem?
answer
Enable proxy arp on the LAN connection for the remote access server.
question
Examine the following output: 4 22 ms 21 ms 22 ms sttlawa01gr02.bb.ispxy.com [154.11.10.62] 5 39 ms 39 ms 65 ms plalca01gr00.bb.ispxy.com [154.11.12.11] 6 39 ms 39 ms 39 ms Rwest.placa01gr00.bb.ispxy.com [154.11.3.14] 7 40 ms 39 ms 46 ms svl-core-03.inet.ispoxy.net [205.171.206.29] 8 75 ms 117 ms 63 ms dia-core-01.inet.ispxy.net [205.151.142.1]Which of the following produced this output?
answer
tracert.
question
You have just connected a new computer to your network. The network user static IP addressing. You find that the computer can communicate with hosts on the same subnet, but not with hosts on a different subnet. No other computers are having a problem Which of the configuration values would you most likely need to change?
answer
Default gateway.
question
Which TCP/IP utility gives you the following output? 2 14 ms <10 ms 14 ms Loopback0.GWI.SLT1.ALTER.NET [137.39.2.123] 3 14 ms <10 ms 13 ms 122.at-6-0-0.XR1.SLT4.ALTER.NET [152.63.91.86] 4 <10 ms 14 ms <10 ms 0.so-0-1-0.TL1.SLT4.ALTER.NET [152.63.1.210] 5 41 ms 41 ms 41 ms 0.so-7-0-0.TL1.PQR3.ALTER.NET [152.63.32.41] 6 42 ms 41 ms 41 ms 0.so.6-0-0.XL1.SEA1.ALTER.NET [152.63.38.82] 7 41 ms 41 ms 41 ms PQS6-0.GW11.SEA1.ALTER.NET [152.63.107.17]
answer
tracert.
question
Which of the following utilities would you use to view the routing table?
answer
route.
question
What is the primary purpose of gateway redundancy?
answer
To overcome a single point of failure on the next hop router.
question
Which of the following protocols provide gateway redundancy? select all that apply
answer
HSRP GLBP VRRP
question
Which process reduces the size of the routing table by advertising a single route as a destination for a group of contiguous subnets?
answer
Route summarization
question
Which of the following routing protocols uses relative link cost as a metric?
answer
OSPF
question
Match the default administrative distance with the route type.
answer
IGRP/100 RIP/120 Static Route/1 EIGRP internal route/90 OSPF/110 EIGRP Summary Route/5 Connected Interface/0 EIGRP external Route/170
question
Your company has decided to temporarily partner with a third-party organization for an upcoming project. This requires your company's network and the third-party's network to be connected via a dedicated WAN connection. what should you do to allow routing information to the exchange?
answer
Configure a border router to use route redistribution.
question
You computer has an IP address of 161.13.5.15. Your computer is on a:
answer
Public network
question
Which of the following IP addresses is a valid IP address for a host on a public network?
answer
142.15.6.1
question
Which of the following is not one of the ranges of IP addresses defined in the RFC 1918 that are commonly used behind a NAT server?
answer
169.254.0.1 - 169.254.255.254
question
You have a computer that is connected to the Internet through a NAT router. You want to use a private addressing scheme for your computer. Which of the following IP addresses could you assign to the computer?
answer
10.0.12.15 172.18.188.67 192.168.12.253
question
You have a small network at home that is connected to the Internet. On your home network you have a server with the IP address of 192.168.55.199/16. All computers on your home network can connect to the Internet. From your work office, you can try to access your home computer using its IP address, but are unable to communicate with the server. You are able to connect to other hosts on the Internet. Why can't you access the server?
answer
Private addresses are not accessible through the Internet.
question
Which of the following associates a port number with a host on a private network?
answer
PAT
question
You have a small network at home that is connected to the Internet. On your home network you have a server with the IP address of 192.138.55.199/16. You have a single public address that is shared by all hosts on your private network. You want to configure the server as a Web server and allow Internet hosts to contact the server to browse a personal website. What should you use to allow access?
answer
Static NAT
question
Which of the following is not one of the ranges of IP addresses defined in RFC 1918 that are commonly used behind a NAT server?
answer
169.254.0.1 - 169.254.255.254
question
You are the network administrator for a small company that implements NAT to access the Internet. However, you recently acquired 5 servers that must be accessible from outside your network. Your ISP has provided you with 5 additional registered IP addresses to support these new servers but you don't want the public to access these servers directly. You want to place these servers behind your firewall on the inside network yet still allow them to be accessible to the public from the outside. Which method of NAT translation should you implement for these 5 servers?
answer
Static
question
You want to connect your small company network to the Internet. Your ISP provides you with a single IP address that is to be shared between all hosts on your private network. You do not want external hosts to be able to initiate connection to internal hosts. What type of NAT should you implement?
answer
Dynamic
question
Which of the following techniques allows incoming traffic addressed to a specific port to move through a NAT router and be forwarded to a specific host?
answer
Port forwarding
question
Which of the following routing protocols divides the network into areas, with all networks required to have an area 0 (area 0 identifying the backbone area)?
answer
OSPF
question
Which of the following routing protocols is classified as a balance hybrid routing protocol?
answer
EIGRP
question
Which of the following routing protocols are classified as link state routing protocols? select two
answer
OSPF IS-IS
question
What are the main differences between the OSPF and IS-IS routing protocols?
answer
OSPF requires an area 0, while IS-IS does not.
question
Which of the following protocols has a limit of 15 hops between and two networks?
answer
RIP
question
What is the main difference between RIP and RIPv2?
answer
Rip is a classful protocol, while RIPv2 is a classless protocol.
question
Under which of the following circumstances might you implement BGP on your company network and share routes with internet routers?
answer
If the network is connected to the internet using multiple ISPs
question
You have a private network connected to the internet. Your routers will not share routing information about your private network with internet routers. Which of the following best describes the type of routing protocol you would use?
answer
IPG
question
You have a router configured to share routing information using RIP. In addition, you have a single static route that identifies a default route for all other networks. The next hop router for the default has changed. You need to make the change with the least amount of effort possible. What should you do?
answer
Manually reconfigure the default route to point to the new next hop router.
question
A router is connected to network 192.168.1.0/24 and network 192.168.2.0/24. the router is configured to use RIP and has learned of networks 192.168.3.0/24 and 192.168.4.0/24. The next hop router for network 192.168.3.0 has changed. You need to make the change with the least amount of effort possible. what should you do.
answer
wait for convergence to take place.
question
you have a network configured to use the OSPF routing protocol. Which of the following describes the state when all OSPF routers have learned about all other routes in the network.
answer
Convergence
question
When multiple routes to a destination exist, what is used to select the best possible route?
answer
Metric
question
Which of the following routing protocols uses paths, rules, and policies instead of a metric for making routing decisions?
answer
BGP
question
Which of the following are true for the IS-IS routing protocol? select two
answer
Divides large networks into areas Supports IPv6 routing
question
One method of preventing routing loops is to not send information about a route back to the router from which the information came. What is this technique called?
answer
Split horizon
question
What information does the next hop entry in a routing table identify?
answer
The first router in the path to the destination network.
question
A router is connected to a network 192.169.1.0/24 and network 192.168.2.0/24. The router is configured to use RIP and has learned of networks 192.168.3.0/24 and 192.168.4.0/24. The router is also configured with a static route of 0.0.0.0 with a mask of 0.0.0.0. The router receives a packet addressed to the network 10.1.0.0/16. What will the router do with the packet.
answer
Forward the packet to the next hop router specified by the route network 0.0.0.0
question
A router is connected to a network 192.168.1.0/24 and network 192.168.2.0/24. The router is configured to use RIP and has learned of networks 192.168.3.0/24 and 192.168.4.0/24. There is no default route on router. The router receives a packet addressed to network 10.1.0.0/16. What will the router do with the packet?
answer
Drop the packet.
question
Which of the following is a characteristic of static routing when compared to dynamic routing?
answer
All routers must be manually updated on the router.
question
Which two of the following tasks do routers perform?
answer
Maintain information about paths through an internetwork. Route data based on logical network addresses.
question
You have been recently hired to mange a network for a small company. Prior to your arrival, the entire network was migrated from IPv4 to IPv6. Which strategy could you imply to help prevent these issues from occurring?
answer
Use a /127 prefix on the backbone segment.
question
You work for a large, multinational organization that has an extensive global network that is interconnected using WAN links and routers.
answer
One of the intermediate routers is an MTU black hole.
