6.3 Exam Questions – Flashcards

Which connector is used with unshielded twisted pair (UTO) cable?

You need to connect the end of a Cat 6 UTP cable to a 110 punch down block. Which tool should you use?

You are installing networking cable in the air space between the ceiling and the roof of a building. Which type of cabling should you use?

Yo need to attatch an RJ-45 connector to the end of a Cat 6 UTP cable. Which tool should you use?

Which of the following are characteristics of coaxial network cable? (2)

Which of the following are advantages of using fiber optic cabling for a network, as opposed to other types of cabling? (2)

You have recently been called to troubleshoot network connectivity problems at a user's workstation. You have found that the network cable runs across high-traffic areas on the floor, causing the cables to wear through and break. You have replaces the cable with a plenum rated, shielded, twisted pair cable. You would like to minimize the problem and prevent it from happening again. What should you do?

Which kind of connector do you use to connect a modem to a standard telephone line?

You have just signed up for a broadband home Internet service that uses coaxial cable. Which connector type will you most likely use?

Which of the following applications is more likely to justify the investment in Category 6 cable?

What is a major benefit of STP over UTP?

What type of cabling could be used for an Ethernet 100BaseT (100 Mbps) network? (2)

You are using a crimper to attach an RJ-45 connector to a Cat 6 UTP cable. You need to use the T568A standard to connect the individual wire to the connector. Which wire should be connected to pin 1?

Which network type uses light pulses to transmit data?