Practice Questions - TestOut Network Pro Chapter 6.1.10 & 6.2.5 - Flashcards

question

Match each switch management method on the left with its corresponding characteristics on the right. Each method may be used once, more than once, or not at all.

answer

Competes with normal network traffic for bandwidth In-band management Uses a dedicated communication channel Out-of-band management Must be encrypted to protect communications from sniffing In-band management Does not compete with normal network traffic for bandwith Out-of-band management Affected by network outages In-band management

question

Match each type of switch on the left with its corresponding characteristics on the right. Each switch may be used once, more than once, or not at all.

answer

Commonly sold at retail stores Unmanaged switch Provide port security features Managed switch Support VLANs Managed switch Provide very few configuration options Unmanaged switch Can be configured over a network connection Managed switch Can be configured over a dedicated communication channel Managed switch

question

You are configuring PuTTY to be used to access the CLi of a Cisco switch Which of the following configuration values would prevent PuTTY from connecting? (Select two)

answer

4600 baud Flow control = RTS/CTS

question

Match the Cisco device password type on the left with its function on the right.

answer

Controls the ability to log on through a LAN or WAN interface configured on the device. VTY Controls the ability to switch configuration modes EXEC Controls the ability to connect to the device using a direct connection Console

question

A router is configured with the login, no password condition for console access. Which of the following statements is true about access via a Telnet or SSH session?

answer

Access is denied.

Unlock the answer

question

You are configuring a switch so that you can manage it via PuTTY from the same network segment as the switch. On the switch, you enter the following commands: switch#config terminal switch(config)#interface vlan 1 switch(config-if)#ip address 192.168.1.10 255.255.255.0 Will this configuration work?

answer

No, the no shutdown command needs to be entered.

Unlock the answer

question

Which command would you use on a switch to enable management from a remote network?

answer

ip default-gateway 192.168.10.185

Unlock the answer

question

What does the ip address dhcp command allow you to do?

answer

Configures the switch to obtain an IP address from a DHCP server.

Unlock the answer

Practice Questions – TestOut Network Pro Chapter 6.1.10 & 6.2.5 – Flashcards

Unlock all answers in this set

Haven't found what you were looking for?

Search for samples, answers to your questions and flashcards